Instructions for how to use your Teeth Whitening Kit

Teeth Whitening Pen and LED Instructions

Step 1: Determine your tooth shade on the shade guide.

Step 2: Brush teeth/or use Brush Up.

Step 3: Apply Vitamin E swab to gums avoiding teeth-Snap off red line, tip over and drain to cotton end.

Step 4: Apply a thin layer of gel from pen to teeth (avoid gums).

Step 5: Turn on LED light (clear plastic tab between batteries must be removed to activate).

Step 6: Hold light up to mouth/or insert clear tab into mouth for hands free.

Step 7: Relax for 5-20 mins!

Step 8: Remove light and rinse mouth. Wipe off clear shield (do not plunge in water).

Tray Preparation

Step 1: Boil a pot of water and let cool for 5 minutes. Submerge one mouth tray into it for 5 seconds or until the mouthpiece begins to wilt slightly.
CAUTION: Keeping the tray submerged for too long will cause them to shrink.

Step 2: Place the mouth tray into your mouth and bite down on it, while at the same time pressing it against the front of your teeth with your fingers and the back of your teeth with your tongue. Let it cool and repeat with the other mouth tray.

Step 3: When you have finished molding both mouth trays, cut the holding-tabs off of the mouthpiece so that you can close your mouth completely when the mouth trays are in your mouth.

Mouth tray and Syringe Steps

Step 1: Place a line of whitening gel on the inner front surface of the tray, and spread it around the front surface (i.e., the surface that will be touching the front of your teeth). You should put just enough gel so that the tray surface has a thin layer of gel. Do not put too much gel as this will cause it to go on your gums and could cause gum irritation. The average mouth tray requires less than 0.5 ml of whitening gel per arch. Repeat with second tray. Recap the syringe for the next treatment until empty.

Step 2: Insert whitening trays in the mouth over the teeth. Set the tray firmly against the teeth. Wipe off any excess gel that has seeped over the brim of the tray onto the gums with a tissue.

Step 3: Relax for 20 minutes!

Step 4: After completion of each whitening session, remove trays and rinse off your teeth and mouth tray for future use.

The best time to use is before bedtime so that you do not come into contact with food afterwards. It is recommended to use for 30 minutes 3-5 days in a row for ultimate results. If using without the light use for 5 days in a row.

IMPORTANT: During the entire length of your whitening treatment, you should avoid staining beverages as much as possible, including coffee, tea, red wine, colas, curry, and citrus beverages. If you must consume these, it is highly recommended to do so through a straw.